This is an easy and efficient way to get you back on the road if your car doesn't start due to a flat battery. Watch VideoJug's guide on how to jump start a car, saving you waiting to be rescued.
Step 1: You will need
- A car with the same voltage battery as your own, fully charged
- 1 set of strong jump-start leads
- 1 wire brush
- 1 pair of rubber gloves
- 1 pair of safety goggles
Step 2: Secure the vehicle
Carry out the jump-start away from traffic if you can and park on a level surface if possible. Apply the parking brake and shift into first gear.
In automatic cars move the gear stick to the parking position.
SAFETY WARNING. Do not smoke whilst carrying out these steps.
Step 3: Open the bonnet
Release the bonnet using the lever in the car's interior and move the bonnet-catch for final release.
Lift the bonnet and locate the prop rod.
Now, secure the bonnet with the rod.
Step 4: Locate the battery
In most cars, it is usually under the bonnet. In others, the battery is under the seat or in a compartment in the back of the car.
Make sure to have easy access to your battery and its terminals.
On most batteries you have to remove the terminal covers in order to attach the jump leads..
Consult your manual If in doubt about your battery's location.
Also determine your battery's voltage.
With the exception of some new models, most cars allow for jump-starts.
Step 5: Check the state of your battery
you may have just left the lights on; in this case your battery should be back on if you follow all the steps.
There may be, however, more serious reasons for a discharged battery that cannot be solved with a jump-start.
Excessive amounts of solidified,
corroded battery acid may be an indicator of severe damage. SAFETY WARNING. Stop if your battery is cracked, corroded or leaking. A jump-start will not work in this case and there is a danger of explosion
SAFETY WARNING. Stop if your battery is cracked, corroded or leaking. A jump-start will not work in this case and there is a danger of explosion.
Step 6: Line up both vehicles safely
The batteries should be as close to each other as possible.
However, have a safety gap between the cars as vehicles should never be touching.
Secure the second vehicle.
Turn the ignition off.
Apply the parking brake.
Step 7: Turn off all electrical devices.
Turn off the lights, indicators and finally the radio.
Accidentally left on devices may get damaged by the high and sudden voltage.
Step 8: Open and secure bonnet
Open and secure the bonnet of the vehicle that is providing the jump start. Do this as made clear in step 2
Step 9: Identify the terminals on the fully charged battery.
Step 10: Identify the terminals on the flat battery.
Step 11: Clean all the terminals
Step 12: Connect the flat battery
Attach a red clip to the positive terminal of the flat battery.
Step 13: Connect the charged battery
Connect the red clip to the positive terminal of the charged battery.
Step 14: Connect the negative on the fully charged battery
Attach the black clip to the negative terminal on the battery that is fully charged.
Step 15: Connect the earth
To earth the flat battery attach the black clip to any metal part on the actual engine itself.
Make sure the metal part is unpainted and free of grease to guarantee a proper flow of electricity.
Connect to a bolt or a nut, they are typically good contact points. This significantly reduces the danger of explosion from batteries.