How to test packet loss

how to test packet loss

Latency, jitter, and packet loss and how they affect my calls

Once a call has successfully been setup, latency, jitter, and packet loss effects are important predictors of overall call quality.

Latency

A measure of the delay in a call. We measure both the round-trip delay between when information leaves point A and when a response is returned from point B, and the one-way delay between when something was spoken and when it was heard. The largest contributor to latency is caused by network transmission delay. Round-trip latency affects dynamics of conversation and is used in our MOS calculations. One-way latency is used for diagnosing network problems.

With round trip latencies above 300 msec or so, users may experience annoying talk-over effects.

Jitter

Jitter refers to how variable latency is in a network. High jitter, greater than approximately 50 msec, can result in both increased latency and packet loss. Let's see how.

When talking to someone it's important that they hear what you say in the same order that you say it, otherwise they won't understand what you're telling them. Unfortunately, jitter causes packets to arrive at their destination with different timing and possibly in a different order than they were sent (spoken), with some arriving faster and some slower than they should.

To correct the effects of jitter, VoIP endpoints collect packets in a buffer and put them back together in the proper timing and order before the receiver hears them. This works, but it's a balancing act. Processing that buffer adds delay to the call, so the bigger the buffer, the longer the delay. Remember the effects of latency? Keep in mind, no matter how big the buffer is, it is finite in size. If voice packets arrive when

the buffer is full then packets are dropped and the receiver will never hear them. These are called discarded packets.

Packet Loss

Just as it's important to hear what someone says in the order they say it, it's also important to hear all of what they're saying. If you miss one out of every 10 words or 10 words all at once, chances are you're not going to understand much of the conversation. This is packet loss some of the voice packets are dropped by network routers or switches that become congested (lost packets), or discarded by the jitter buffer (discarded packets).

Knowing the average packet loss for a call gives you an overall sense for the quality of the call. A call with less than 1 percent average packet loss will always sound better than a call with 10 percent loss. But average loss doesn't tell the whole story. You need to know what type of packet loss you encountered.

There are two kinds of packet loss: "random" and "bursty". Think about two calls each with average 1 percent packet loss. Call A loses one in every 100 packets over the entire call (random loss) while Call B loses 100 packets in two clumps at the beginning and the end of the call (bursty loss). Which call would you rather have? That's why we report not just the average packet loss but also the type of loss and information on any bursts of packet loss during your call (reported as loss periods). It matters.

When you have choppy voice on your line, you should immediately Determine the JITTER on your ISP connection .

padding-top:5;padding-bottom:5;padding-right:5;padding-left:5;

font-weight:bold">NOTE: Try and isolate the problem even further by testing your ATA on another BroadBand connection.

Source: www.dslreports.com

Category: Forex

Similar articles: